Hybrid stepper motor
Motion Control Products NEMA 14 Standard (M35ST)
35 mm 2-phase hybrid stepper with six windings across 34-45 mm lengths; 0.9 degree version on request.
Key specifications
| Frame sizes | 35 mm |
|---|---|
| Feedback | none (open loop); optical encoder option |
| Current (max) | 2 A |
| Holding torque | 0.147–0.441 Nm |
| NEMA sizes | 14 |
| Step angle | 1.8 ° |
| Step angle options deg | 1.8, 0.9 |
| Rated current range | 0.5-2.0 |
| Rated voltage range | 2.77-6.6 |
| Length range | 34-45 |
| Leads | 4 |
| Phases | 2 |
Series ranges as published; individual models vary. The full datasheet, drawings and CAD models are available on request.
Options
- single or double shaft
- optical encoder
- planetary gearbox
- 0.9 deg step angle on request
- custom windings
- alternative mounting flanges
Typical applications
AutomationRoboticsPrecision motion control
Other hybrid stepper motor series
Motion Control Products NEMA 8 High Torque (M20STH)Motion Control Products NEMA 11 High Torque (M28STH)Motion Control Products NEMA 16 (M39ST / M39ST..J)Motion Control Products NEMA 17 High Torque (M42STH)Motion Control Products NEMA 23 High Torque (M57STH / M60STH)Motion Control Products NEMA 34 High Torque (M86STH)Motion Control Products NEMA 42 High Torque (M110STH)Leadshine CM Series (2-phase)
Spec builder
Configure Motion Control Products NEMA 14 Standard (M35ST)
Select every part you need, answer the questions an applications engineer would ask, and see your summary before we ask for any details.
- 1Products
- 2Performance
- 3Environment
- 4Volumes
- 5Your spec
Step 1 of 5
Engineer support
Need Motion Control Products NEMA 14 Standard (M35ST) or a complete system around it?
Tell us what you need, whether it is this part, an equivalent or a complete axis built around it. An engineer will review your requirements and reply, normally within one working day.
- Reviewed by an engineer, not an autoresponder
- Like-for-like and better-fit alternatives
- Standard, modified and custom options
Prefer to configure it? Use the spec builder.